Edge jump/zh: Difference between revisions

From DDraceNetwork
(Updating to match new version of source page)
No edit summary
 
(23 intermediate revisions by 4 users not shown)
Line 1: Line 1:
<languages/>
<languages/>
<div lang="en" dir="ltr" class="mw-content-ltr">
'''边缘跳'''(英语:Edge jump)指一种在平台边缘上进行跳跃操作的技巧,而使用这项技巧时,通常平台正上方会存在冻结区域,传送区域或即死区域等。因为这些区域的[[Special:MyLanguage/Collision|判定区域]]比看上去要小,所以玩家可以站在平台边缘而不会触发这些区域的机制。在视觉上,Tee可半身进入到冻结或传送区域内。而即死区域的判定区域则比较大,想站在即死区域边缘会更加困难。判定区域详情参阅[[Special:MyLanguage/Collision|碰撞]]一页。
Edge jump refers to the act of jumping to or from the edge of a block that contains usually freeze, teleport, or a kill tile. Edging these tiles is made possible because the hitbox of them is smaller than their visual appearance. The tee can go up to halfway into the freeze visually before they are considered in that tile. Kill tiles have a larger hit box, so edging them is much more difficult. See [[Special:MyLanguage/Collision|Collision]] for more info on hitboxes.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
<span id="Single_and_double_freeze_edge_jump"></span>
== Single and double freeze edge jump ==
== 单双格宽度冻结区域边缘跳 ==
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
多次练习可简单实行单格或双格冻结区域边缘跳。首先在边缘处跳起来,之后下降到某一位置时候按住方向键,即可跳到冻结区域另一侧的边缘处。玩家经过大量练习后即可熟能生巧、完美掌握边缘跳移动时机。
Going to the other side of a one-tile and two-tile freeze block are easily doable with enough practice. Simply jump, and on the way down go in the direction of the other edge. Practice should make perfect here.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
<span id="Triple_freeze_edge_jump"></span>
== Triple freeze edge jump ==
== 三格宽度冻结区域边缘跳 ==
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
三格冻结区域边缘跳难以像单双格的那般稳定。但如果玩家站在边缘时位于特定的x坐标上,则可百分百触发该项技巧。按下{{key press|ctrl|shift|D}}来开启调试参数,屏幕右上方将显示玩家坐标,玩家应注意x坐标小数点后面的数值。在DDNet 16.2版本后,玩家可以在设置 > 游戏界面 > HUD > DDRace HUD里开启“显示玩家坐标”来查看玩家所处的坐标位置。
Going to the other side of a three-tile freeze block is inconsistent if you don't know what you're doing. Successfully going to the other side of the edge is only made possible when on specific x-coordinates - which also makes it possible to go to the other side 100% of the time, assuming you are on the correct spot. To check your coordinates, press <code>Ctrl</code> <code>+</code> <code>Shift</code ><code>+</code> <code>D</code>. The coordinates are on the right hand side of the screen - only the decimal place of the x-coordinate is useful in this case.
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
特定x坐标小数点后数值如下:
The x-coordinates are as such:
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
{| class="wikitable"  
{| class="wikitable"
|-
</div>
!方向
 
!跳跃类型
<div lang="en" dir="ltr" class="mw-content-ltr">
! colspan="4" style="text-align:center;" |X 坐标/横坐标
!Direction
</div>
 
<div lang="en" dir="ltr" class="mw-content-ltr">
|-
|-
</div>
| rowspan="2" |
 
向右
<div lang="en" dir="ltr" class="mw-content-ltr">
|一段跳
|Going to the right
</div>
 
<div lang="en" dir="ltr" class="mw-content-ltr">
|.62
|.62
</div>
|.63
 
<div lang="en" dir="ltr" class="mw-content-ltr">
|.66
|.66
</div>
<div lang="en" dir="ltr" class="mw-content-ltr">
|.81
|.81
</div>
<div lang="en" dir="ltr" class="mw-content-ltr">
|-
|-
</div>
|二段跳
 
|.56
<div lang="en" dir="ltr" class="mw-content-ltr">
|.69
|Going to the left
|.72
</div>
|.84
 
|-
<div lang="en" dir="ltr" class="mw-content-ltr">
| rowspan="2" |向左
|一段跳
|.16
|.31
|.34
|.34
</div>
|
|-
|二段跳
|.13
|.25
|.28
|.41
|}


<div lang="en" dir="ltr" class="mw-content-ltr">
当玩家位于以上特定坐标点时,玩家只需要同时按住跳跃键与前进方向键即可完成三格冻结区域边缘跳。但偶然情况下,两个按键不一定会被同时触发,因此为保证两个动作可以被同步执行,玩家可以进行以下绑定:
|.31
</div>
 
<div lang="en" dir="ltr" class="mw-content-ltr">
|.16
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
bind 【按键】 "+jump; +right"
|}
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
Once you are on the right coordinates, you can either tap jump and the direction at the same time (which may be inconsistent), or make it guaranteed by using binds:
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
<small>*由于[[wikipedia:Floating-point_arithmetic|浮点数算法]]的特性,这些跳跃在离坐标(0,0)越远处越难以成功。但是在相同坐标位置,同样的一次跳跃永远会得到相同的结果。但是,大多数的地图没有那么大,所以这些列出的坐标基本上都是可用的。</small>
bind x "+jump, +right"
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
<span id="Misc_Techniques"></span>
== Misc Techniques ==
== 进阶技巧 ==
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
<span id="Auto_edge_jump"></span>
=== Auto edge jump ===
=== 自动边缘跳 ===
</div>


<div lang="en" dir="ltr" class="mw-content-ltr">
当玩家使用二段跳跃后即将抵达一处边缘时,可以快速松开并再次按住跳跃键,玩家便能够在接触边缘后立即进行一次跳跃。地图[https://ddnet.org/maps/Toe-32-Taps Toe Taps]便是以此机制设计的。
When using double jump against an edge and quickly holding the jump button down again, it is possible to automatically jump off of it right when you reach it. An example of a map that is designed around this mechanic is Toe Taps.
</div>

Latest revision as of 03:21, 6 October 2023

边缘跳(英语:Edge jump)指一种在平台边缘上进行跳跃操作的技巧,而使用这项技巧时,通常平台正上方会存在冻结区域,传送区域或即死区域等。因为这些区域的判定区域比看上去要小,所以玩家可以站在平台边缘而不会触发这些区域的机制。在视觉上,Tee可半身进入到冻结或传送区域内。而即死区域的判定区域则比较大,想站在即死区域边缘会更加困难。判定区域详情参阅碰撞一页。

单双格宽度冻结区域边缘跳

多次练习可简单实行单格或双格冻结区域边缘跳。首先在边缘处跳起来,之后下降到某一位置时候按住方向键,即可跳到冻结区域另一侧的边缘处。玩家经过大量练习后即可熟能生巧、完美掌握边缘跳移动时机。

三格宽度冻结区域边缘跳

三格冻结区域边缘跳难以像单双格的那般稳定。但如果玩家站在边缘时位于特定的x坐标上,则可百分百触发该项技巧。按下ctrl+⇧ Shift+D来开启调试参数,屏幕右上方将显示玩家坐标,玩家应注意x坐标小数点后面的数值。在DDNet 16.2版本后,玩家可以在设置 > 游戏界面 > HUD > DDRace HUD里开启“显示玩家坐标”来查看玩家所处的坐标位置。

特定x坐标小数点后数值如下:

方向 跳跃类型 X 坐标/横坐标

向右

一段跳 .62 .63 .66 .81
二段跳 .56 .69 .72 .84
向左 一段跳 .16 .31 .34
二段跳 .13 .25 .28 .41

当玩家位于以上特定坐标点时,玩家只需要同时按住跳跃键与前进方向键即可完成三格冻结区域边缘跳。但偶然情况下,两个按键不一定会被同时触发,因此为保证两个动作可以被同步执行,玩家可以进行以下绑定:

bind 【按键】 "+jump; +right"


*由于浮点数算法的特性,这些跳跃在离坐标(0,0)越远处越难以成功。但是在相同坐标位置,同样的一次跳跃永远会得到相同的结果。但是,大多数的地图没有那么大,所以这些列出的坐标基本上都是可用的。

进阶技巧

自动边缘跳

当玩家使用二段跳跃后即将抵达一处边缘时,可以快速松开并再次按住跳跃键,玩家便能够在接触边缘后立即进行一次跳跃。地图Toe Taps便是以此机制设计的。